run local picture stream for windows does not use configured picture identifier
If the (Experimental) Run local camera stream (Windows only)
is started during the start-up, the picture identifier is shown to check and update. Here, I would assume that the before-configured identifier (through the Update setting
button) is shown, which is not the case.
Configure the identifier:
- Click
Update settings
(violet button with gears) - Choose
Streamed image via bucket
- Click
Select
- Enter the URL of the prepared bucket service endpoint
- Click
Ok
- Choose picture identifier used for your workshop
Start the stream:
- Open the ´Scene2Model Wizard´
- Choose
(Experimental) Run local camera stream (Windows only)
- Click
Select
- Check your picture identifier (and update if necessary)